Mazda MX-5 Miata 2005 - Page 10

Fig. 10: Reshaping Sealant
Courtesy of MAZDA MOTORS CORP.
10. Install the rear window molding with the molding joint at the top.
 If the molding is too long, cut the excess molding 10 mm {0.39 in} inside the molding joint edge.
Hardening time of sealant
SEALANT HARDENING TIME
Temperature Surface hardening time Time required until vehicle can be put into service
5°C {41°F} Approx.1.5 h Approx.12 h
20°C {68°F} Approx.1 h Approx.4 h
35°C {95°F} Approx.10 min Approx.2 h
2005 Mazda MX-5 Miata
2005 ACCESSORIES & EQUIPMENT Exterior Trim - MX-5 Miata
Microsoft
Saturday, July 04, 2009 12:04:28 PM Page 10 © 2005 Mitchell Repair Information Company, LLC.