Mazda 0000-89-N01 - User Manual

51374A 12-11-06
INSTALLATION INSTRUCTIONS
INSTRUCCIONES DE INSTALACIÓN
INSTRUCTIONS DINSTALLATION
Genuine Accessories
Accesorios Genuinos
Accessoires Dorigine
0
Center Support
Install Center Supports
3
0000-89-N01 (Port)
0000-8L-N01 (Dealer)
2007 > CX9
ROOF RAILS
Part Number:
Número De Parte:
Numéro De Pièce:
Applicable Models:
Modelos Aplicables:
Modèles Concernés:
1
2
Before Installation
Antes de la instalación
Avant linstallation
A) Read entire installation instruction sheet before proceeding.
Lea toda la hoja de las instrucciones de instalación antes de proceder
Lire toutes les instructions avant de procéder à linstallation.
B) Wear eye protection.
Use protección visual.
Porter des lunettes de protection.
C) The front and rear rails are clearly marked on the bottom pad.
Los rieles delantero y posterior están claramente identificados en la almohadilla inferior.
Une inscription très lisible sur le coussinet inférieur du rail permet de déterminer
si celui-ci va à lavant ou à larrière du véhicule.
Note: Maximum Load - 100 Lbs Evenly Distributed
Carga Máxima - 100 lbs Distribuidas Uniformemente
Charge Maximum - 100 lbs Également Distribuées
T-25 driver
Destornillador t-25
Tournevis t-25
Safety goggles
Gafas de seguridad
Lunettes de sécurité
TOOLS REQUIRED
Herramientas necesarias
Outils requis
PACKAGE CONTENTS
Contenido del paquete
Contenu de lemballage
Side Rails (1LH, 1RH)
Covers (Qty. 2 Pairs)
Tapas (Cant. 2 Pares)
Capuchons (Qté = 2 Paires)
(LH SHOWN RH TYPICAL)
Cover Kit
Service Part # 0000-8L-N05
Hardware Kit
Service Part # 0000-8L-N04
To remove push in arrow direction
Para retirar empuje en la dirección de la flecha
Pour retirer, pousser dans le sens de la flèche
To remove push in arrow direction
Para retirar empuje en la dirección de la flecha
Pour retirer, pousser dans le sens de la flèche
Remove RH ditch mold caps
Retire las tapas de las molduras del lado derecho
Retirer les capuchons des rainures de drainage droites
Remove LH ditch mold caps
Retire las tapas de las molduras del lado izquierdo
Retirer les capuchons des rainures de drainage gauches
M6 Screws (T-25)
9.0 N.m Torque
Tornillos M6 (T-25)
Torsión 9.0 N.m
VIS M6 (T-25)
Couple de serrage de 9,0 N.m
Front of
Vehicle
Front of
Vehicle
Front of
Vehicle
M6 Screws (T-25) (Qty. 6)
Tornillos M6 (T-25) (Cant. 6)
Vis M6 (T-25) (Qté = 6)
Center Supports (Qty. 2)
M4 Screws (T-25) (Qty. 2)
Tornillos M4 (T-25) (Cant. 2)
Vis M4 (T-25) (Qté = 2)

Summary

Before Installation and Preparation

Read Installation Instructions

Read the entire installation instruction sheet before proceeding with the installation.

Wear Eye Protection

Wear appropriate eye protection during the installation process.

Identify Front and Rear Rails

Confirm the front and rear rails are clearly marked on the bottom pad.

Ditch Mold Cap Removal

Remove RH Ditch Mold Caps

Remove the ditch mold caps from the right side of the vehicle.

Remove LH Ditch Mold Caps

Remove the ditch mold caps from the left side of the vehicle.

Install Center Supports

Mount Center Supports

Install the center supports using M6 screws with specified torque.

Install Side Rails

Mount Side Rails

Install the side rails onto the vehicle's roof.

Secure Side Rails to Center Supports

Fasten Side Rails

Secure the installed side rails to the center supports with M4 screws.

Install Roof Rail Covers

Install Front Covers

Install the front covers onto the roof rails.

Install Rear Covers

Install the rear covers onto the roof rails.

Complete Side Rails Installation

Finalize Side Rails

Complete the installation of the side rails and place instructions in the glove box.

Mazda 0000-89-N01 Specifications

General

Brand	Mazda
Model	0000-89-N01
Category	Automobile Accessories
Language	English