Need help?Do you have a question about the MB QUART MBQR-SUB-2 and is the answer not in the manual?
General| Power Handling (RMS) | 150 Watts |
|---|---|
| Power Handling (Peak) | 300 Watts |
| Size | 8 inch |
| Type | Subwoofer |
| Impedance | 4 ohm |
| Frequency Response | 30Hz - 500Hz |
| Voice Coil Configuration | Dual Voice Coil |
| Voice Coil | 2 in |
Provides a video guide for installing the MB Quart vehicle-specific products.
Details the components of the MBQR-SUB-2 subwoofer system package.
Outlines the 1-year warranty coverage and requirements for claims.
Provides contact information and resources for technical assistance.
Lists all necessary tools and supplies for completing the installation process.
Highlights critical safety measures to follow before starting the installation.
Suggests preparing all components and wiring harnesses for efficiency.
Details how to check for and identify the bus bar harness for power connection.
Explains options for enhancing the subwoofer with Stage 2 audio systems.
Provides information on the availability of Ride Command in Polaris RZR models.
Specifies the correct Stage 2 audio system for RZR models equipped with Ride Command.
Identifies the appropriate Stage 2 system for RZRs lacking the Ride Command feature.
Lists optional accessories for the Polaris RZR audio system.
Instructions for removing the center hood section to access the bus bar.
Details on removing dashboard screws and unplugging gauges.
Guidance on detaching the grab bar from the dashboard assembly.
Steps for removing the dash pocket and its retaining hardware.
Instructions for removing central dashboard fascia screws and loosening the dash.
Steps for releasing side clips on the passenger side front dash assembly.
Process for removing the glove box by detaching mounting bolts.
Instructions for removing the center hood and grab bar for this specific RZR model.
Guidance on removing plastic clips to detach the center shroud or cover.
Steps for removing top dash cover assembly screws and lifting the assembly.
Instructions for removing ECU brackets or pocket screws based on vehicle configuration.
Steps for removing the lower pocket and passenger side cubby.
Guidance on removing screws securing the center switch hardware.
Instructions for detaching ignition switch nuts and disconnecting wires from switches.
Process for carefully pulling the dashboard fascia away from the vehicle.
Steps for removing the glove box by detaching mounting bolts.
General guidelines for mounting the subwoofer enclosure across all RZR models.
Instructions on how to position the subwoofer enclosure correctly before mounting.
Guidance on hand-threading and tightening enclosure mounting bolts.
Details on evenly tightening bolts to ensure proper seating against the vehicle frame.
Instructions for routing the subwoofer wiring harness to the amplifier area.
Explains how to connect the amplifier to existing Stage 2 systems or standalone.
Details the recommended initial settings for the NA2-400.1 mono amplifier.
Instructions for reconnecting the negative battery terminal after installation.
Procedure for turning on the vehicle's ignition and source unit.
A checklist to confirm proper connectivity of the amplifier and subwoofer.
Explains the function of Gain, Low Pass Filter, Subsonic, and Boost controls.
A critical step-by-step guide for setting amplifier gain correctly to avoid distortion.
A checklist for reassembling panels and components for specific RZR models.
A checklist for reassembling panels for newer RZR models.
A final checklist to ensure all components are secure before operating the vehicle.
To Next Page
