20
MC Technologies Router program
These settings apply for routers with 2.xx.x firmware (see Release Version under "System/Hardware").
Important note! Routers with Release 1.xx.x firmware cannot be updated to Version 2.xx.x.
Please contact the manufacturer.
1.6.2 General Setup (Firmware 2.xx.x)
General Set-up
Firewall Disabled: The integrated firewall is deactivated, no filtering of data packets.
Enabled: The integrated firewall is activated (default).
Port forwarding Disabled: Port forwarding via NAT table is blocked.
via NAT table Enabled: Port forwarding via NAT table is allowed.
Block outgoing Netbios Disabled: Outgoing NetBIOS requests are allowed.
Enabled: Outgoing NetBIOS requests are blocked (default).
Ping (ICMP) external Disabled: A ping request from the external IP network to the router is ignored (default).
Enabled: A ping request from the external IP network to the router is returned.
Web based Management Disabled: External configuration via the web interface is not possible (default).
external Enabled: External configuration via the web interface is possible.
NAT (Masquerade) Disabled: No IP masquerading performed.
external Enabled: IP masquerading is activated. Communication from a private, local network
to the Internet is allowed (default).
Device access via SSH Disabled: Local SSH access to the router is not possible (default).
Enabled: Local SSH access to the router is possible.
External access via SSH Disabled: Remote SSH access to the router is not possible (default).
Enabled: Remote SSH access to the router is possible.
General Set-up
Firewall Disabled: The integrated firewall is deactivated, no filtering of data packets.
Enabled: The integrated firewall is activated (default).
Port forwarding Disabled: Port forwarding via NAT table is blocked.
via NAT table Enabled: Port forwarding via NAT table is allowed.
Block outgoing Netbios Disabled: Outgoing NetBIOS requests are allowed.
Enabled: Outgoing NetBIOS requests are blocked (default).
Ping (ICMP) external Disabled: A ping request from the external IP network to the router is ignored (default).
Enabled: A ping request from the external IP network to the router is returned.
External SNMP access Disabled: Remote SNMP Access is not possible.
Enabled: Remote SNMP Access is possible.
External Web based Disabled: External configuration via the web interface is not possible (default).
Management via HTTP Enabled: External configuration via the web interface is possible.
NAT (Masquerade) Disabled: No IP masquerading performed.
external Enabled: IP masquerading is activated. Communication from a private, local network
to the Internet is allowed (default).
Device access via SSH Disabled: Local configuration via the web interface and https is not possible (default).
Enabled: Local configuration via the web interface and https is possible.
External access via SSH Disabled: External configuration via the web interface and https is not possible (default).
Enabled: Configuration via the web interface and https is possible.
To Previous Page
Loading...