To Next PageTo Next Page
Need help?Do you have a question about the McCulloch M125B92RB and is the answer not in the manual?
General| Brand | McCulloch |
|---|---|
| Model | M125B92RB |
| Category | Lawn Mower |
| Language | English |
Read instructions, learn controls, and understand proper equipment use.
Reduce fire risk, inspect area for debris/objects, wear appropriate footwear, check fuel.
Operate safely, avoid hazards like confined spaces, slopes, and bystanders.
Keep hardware tight, store safely, cool engine, keep engine area clean, check grass catcher.
Mount steering wheel, adapter, shaft, and secure with bolts.
Attach seat to tractor, adjust position for operator comfort.
Install battery cover, connect cables correctly, handle battery with care.
Assemble bagger components to tractor, including chute, support brackets, and tube.
Adjust bagger position horizontally and vertically for proper function and appearance.
Identifies and explains the function of various controls like light switch, throttle, pedals, levers.
Regulates engine revs and blade rotation speed.
Applies brake and disengages motor when pushed down.
Controls transmission and allows selection of four positions: Neutral, Slow, Fast, Reverse.
Connects/disconnects drive to cutting unit using a lever.
Lifts/lowers cutting unit quickly for transport or passing over obstacles.
Controls engine start, stop, and Reverse Operation System (ROS).
Secures the tractor in place by engaging the brake.
Used for starting a cold engine.
Refuel with unleaded petrol outdoors, do not smoke, ensure cap is tight, store fuel safely.
Check engine oil level before each run, ensure tractor is horizontal, add correct oil type.
Check tire pressure regularly and maintain specified PSI for front and rear tires.
Ensure cutting unit is in transport position, clutch disengaged, brake applied, then turn ignition to START.
Push gas control halfway, turn ignition to START, then to ON, push choke in when engine runs smoothly.
Lower cutting unit, engage unit, select speed, release brake pedal.
Ensures safety by requiring operator presence and proper use of ROS.
Clear lawn, mark obstacles, start high cut, avoid wet grass, clean unit after use.
Turn off alarm, position tractor, set brake, raise handle to dump clippings.
Instructions for converting to mulching, rear discharge, or bagging.
Disconnect spark plug, press brake, engage parking brake, set gear to neutral, disengage clutch, switch off engine.
Raise hood, disconnect headlight wire, remove hood from tractor.
Perform periodic maintenance, check oil, lubricate points, check battery, clean air screen, keep tractor clean.
Remove and install mower blades, ensuring proper alignment and torque.
Check brake performance; service if tractor stops in more than 5 feet.
Remove belt from pulleys, retainer springs, and axle taps.
Adjust cutting unit for optimal results, ensuring front edge is lower than rear edge.
Adjust motion control lever to ensure neutral position and prevent creeping.
Checks fuel, spark plug, connections, and carburetor for issues.
Checks gear, spark plug, carburetor settings, air filter, fuel ventilation, and ignition.
Checks air filter, spark plug, carburetor, and fuel system for blockages or defects.
Checks for overloaded engine, blocked air inlets, damaged fan, low oil, or ignition issues.
Checks fuse, battery cells, and cable connections.
Checks bulbs, switches, and wiring for faults.
Checks for loose blades, engine, or blade imbalance.
Checks for blunt blades, skew unit, grass conditions, tire pressure, gear, or drive belt.
Clean machine, touch up paint, change oil, drain fuel, service cylinder, store battery, store machine indoors.
Provides information needed for ordering spare parts and contacting dealers for warranty.
