C1000 Controller / C1000T Tube Preamplifier Output and Control Connection Diagram
4B
McIntosh Left Channel Power Amplifier
Connect to
AC Outlet
Note: Refer to the C1000 Owner’s Manual page 4 for additional connection information.
Connection Legend:
Data Cable*- Controller to Preamplifier Cable -
Sensor/Keypad Cable - Ground Wire -
Power Control Cable* - AC Power Cords -
Audio Signal Cable - Loudspeaker Cable -
* 2 conductor shielded with 1/8 inch stereo mini phone plug on each end.
McIntosh Right Channel Power Amplifier
To Previous Page
Loading...
Need help?
General