McIntosh M Q112 - Audio Specifications; General Specifications; Power Requirements; Overall Dimensions

10
Audio Specications
Rated Output Voltage
2.5V Unbalanced
5V Balanced
Maximum Output Voltage
10V Unbalanced
20V Balanced
Maximum Input Voltage
10V Unbalanced
20V Balanced
Voltage Gain (all controls at)
Unbalanced IN to OUT 0dB
Balanced IN to OUT 0dB
Frequency Response (all controls at)
+0, -0.5dB from 20Hz to 20,000Hz
+0, -1dB from 10Hz to 100,000Hz
Signal to Noise Ratio (A-Weighted)
115dB (below rated output)
Total Harmonic Distortion
0.005% from 20Hz to 20,000Hz
Input Impedance
10k ohms Unbalanced
20k ohms Balanced
Output Impedance
500 ohms Unbalanced
1000 ohms Balanced
Equalizer Controls
±12dB at 25Hz, 50Hz, 100Hz, 200Hz, 400Hz,
1kHz, 3kHz, and 10kHz
Tilt Control
±6dB at 20Hz and 20kHz
650Hz Tilt Axis
General Specications
Power Control Input
5-15VDC, less than 1mA
Power Control Output
12VDC, 25mA
Power Requirements
Field AC Voltage conversion of the MQ112 is not
possible. The MQ112 is factory congured for
one of the following AC Voltages:
100 Volts, 50/60Hz at 30 watts
110 Volts, 50/60Hz at 30 watts
120 Volts, 50/60Hz at 30 watts
220 Volts, 50/60Hz at 30 watts
230 Volts, 50/60Hz at 30 watts
240 Volts, 50/60Hz at 30 watts
Standby Power, less than 0.5 watts
Overall Dimensions



Weight
15 pounds (6.8 kg) net
29.5 pounds (13.4 kg) in shipping carton
Shipping Carton Dimensions


