McIntosh RS100 - Detailed Specifications and Packing; Technical Specifications and Packing Instructions

12
6SHFL¿FDWLRQVDQG3DFNLQJ,QVWUXFWLRQV
Audio Specifications
Aux Iput Sensitivity
200mV
Aux Input Impedance
10,000 ohms
Subwoofer Output Filter
2,000Hz Low Pass
Subwoofer Output Impedance
200 ohms
Type A connector with Host Mode.
Used for firmware Updates and Network Connec-
tion using a special adapter (see page 2, note 3 for
DGGLWLRQDOLQIRUPDWLRQ
USB Connector
,(((DEJQ:L)L'XDO%DQG:36
Wi-Fi Connectivity
Power Requirements
100-240 Volts, 50/60Hz at 60 Watts
Standby: Less than 0.5 watt
Overall Dimensions
:LGWKLVLQFKHVFP
+HLJKWLVLQFKHVFP
'HSWKLVLQFKHVFPLQFOXGLQJWKH)URQW
Panel and connection cables.
Weight
SRXQGV.JQHWLQFOXGHVWKHH[WHUQDO
3RZHU6XSSO\SRXQGV.JLQVKLSSLQJ
carton
Shipping Carton Dimensions
:LGWKLVLQFKHVFP
+HLJKWLVLQFKHVFP
'HSWKLVLQFKHVFP
General Specifications
Packing Instructions
In the event it is necessary to repack the equipment
for shipment, the equipment must be packed exact-
ly as shown below. Failure to do this will result in
shipping damage.
Use the original shipping carton and interior parts
only if they are all in good serviceable condition.
,IDVKLSSLQJFDUWRQRUDQ\RIWKHLQWHULRUSDUWV
are needed, please call or write Customer Service
Department of McIntosh Laboratory. Refer to
page 2. Please see the Part List for the correct part
numbers.
Quantity Part Number Description
1 310573SP Shipping carton only
1 310569SP Left side foam pad
1 310572SP Right side foam pad
1 310570SP Nonwoven bag
1 310571SP Plastic bag
1 310568SP Accessory box
Loudspeaker Specifications
System Driver Complement
2QHLQFK:RRIHU0LGUDQJHZLWKDFRXVWLFSRUW
One 3/4 inch Dome Tweeter
Frequency Response
55Hz - 20kHz
Crossover Frequency
2,000Hz
Enclosure Finish
High Gloss Black
Grille Finish
Black Knit Cloth
Grille Attachment
Magnetic