ASSEMBLY
RGURE 4: InstalltheWheel Drive Controlrodon topand insert
cotterpin.Then, open itsbottom to securelyfastenit.
RGURE 7: Putthebentend oftherodthroughthe holeofthedrive
dutch lever.
INSTAWNG THROTTLE CONTROL:
1. One end of the throttle control is factory installedto the
carburetor.The other end needs to be installedin the upper
handle.
2. Take hold of thecontrol leverat the otherend ofthe cableand
route the throttle cable under and behind the panel located
where the upper handle is boltedto the Ic_,_rhandle.
3. See Fig.8:Holdthe control leveratthe end ofthe throttlecable
and twist itslightly so the knob will pass through the slot in the
upper handle.
RGURE 5: Insertthe red at the bottom of.theWheelDrive Lever
andsecurewitha cotterpin.
Clutch
aring
FIGURE 6: PUtthe bend end of the rodthrough the bole of the
idlerbracket.Secure laterwitha cotter pin.
5
FIGURE 8: Twistlever so knob will passthrough slot in panel.
To Next Page
Loading...
