MCZ BOXTHERM 70 AIR 9 BASIC M1 - Page 32

32
27-SETTINGS MENU
Modifying the pellet recipe and air recipe
This function is for adapting the stove to the type of pellet in use. In fact, since there are many types of pellets on the market, operation
of the
stove varies signicantly depending on the good or poor quality of the fuel.
The amount of pellets in the brazier can be increased or reduced:
•Ifthepelletstendtojaminthebrazierduetoanexcessoffuel
•Iftheameisincreasinglyhigherevenatlowpowervalues
•Iftheameisalwayslow
ATTENTION! When you access the pellet recipe menu, a POP-UP appears prompting a password. Enter “1234”-
To edit the AIR recipe, select one of the values available.
The available values are:
-- 2 = - 10%
- 1 = - 5%
0 = (default value)
1 = + 5%
2 = + 10%
This function is used to adjust combustion air if the ame
is too high or too low.
To edit the PELLET recipe, select one of the values
available.
The available values are:
- 3 = Reduction of pellet loading by 20% at all power
values
- 2 = Reduction of pellet loading by 13% at all power
values
- 1 = Reduction of pellet loading by 6% at all power
values
0 = no change
1 = Increase of pellet loading by 3% at all power values
2 = Increase of pellet loading by 6% at all power values
3 = Increase of pellet loading by 10% at all power values
Attention! It is preferable that this mode
(“Pellet recipe”/ “Adaptive mode”) be
activated under the supervision of a
qualied technician.