MDG ME2 - Working with the Me2

Me2, Fog Generator
Operating Guide, Rev: A/a 9 / 30
Working with the Me2
The MDG Me2 Fog Generator is quite easy to operate and requires no preventive maintenance.
Switch On the power.
The MDG Me2 will display during four (4) seconds, the following message:
Me2, by
MDG Fog Generators
Testing BootLoad….
These four seconds allow you to connect the generator to your PC, via a USB cable, to update
the firmware of the control board (see BootLoader for further details).
Then, the MDG Me2 will display during one (1) second, the following message:
Me2
by
MDG Fog Generators Ltd
(V: x.xx – F: y.yyy)
where ‘x.xx’ is the version of your generator, and ‘y.yyy’ is the firmware of the program.
The program will load the configuration parameters saved in the EEPROM memory.
Finally, the screen will display the menu.