Step 4:
Treating your face
Prepare your treatment area (women's faces below the
cheek line):
• You can shave (dark hair), wax or tweeze (light hair)
before using the mē.
• Make sure to clean your skin of any wax or hair residue
before starting treatment.
• Do not treat if you feel your skin is irritated from waxing
or tweezing.
• Gently place the device on your skin, so that both RF
bars are in complete contact with the skin. The device
will not work unless both RF contact bars are touching
your skin.
• Allow one ash of elōs energy on your rst target area.
• Lift the device and place it on the the next adjacent
area and wait for each ash of elōs light to be emitted
before moving to the next spot.
• Repeat this stamping motion until
you have completed 2-3 passes of
the entire area.
Treatment tips
When using the mē on difcult to treat areas (e.g.
underarms) apply the device in two directions: left/right
and up/down for full coverage (image A).
• If you nd the light from the elōs ash too bright, you can
wear sunglasses or goggles for your comfort.
• DO NOT hold the treatment window still over one spot
and ash multiple light ash on the skin. Doing so may
generate too much heat, which can damage the skin.
• The mē will automatically shut off if it is not in use for
more than 3 minutes. Press the power button to turn the
device back on.
A
To Next Page
Loading...
