Mecmesin Tornado - Option Explanations for ON States

RS232 Command Responses: Information
It is possible to remotely interrogate your Tornado by sending the following RS232
commands. This will inform you which settings are currently configured.
Command: M
Response Tornado Display Mode
Normal Normal Mode
MaxC
Max Counter-clockwise
MaxT
Max Clockwise
MaxDual Dual Max Screen
1stC
1
st
Peak Counter-clockwise
1stC Dual
1
st
Peak Counter-clockwise Screen
1stT
1
st
Peak Clockwise
1stT Dual
Dual 1
st
Clockwise Screen
Command: U
Response for Torque Sensor
N.m
N.cm
mN.m
gf.cm
kgf.cm
kgf.m
lbf.ft
lbf.in
ozf.in
Command: C
The torque sensor size, in the current selected units.
Note: ‘xxxx’ will be transmitted if the torque sensor is not calibrated, or has a serious fault.
Contact Mecmesin or your supplier.
page 33