MedeaWiz Sprite DV-S1 - Motion Sensor Wiring

MedeaWiz® Sprite®
.
23 | P a g e
Motion Sensor Wiring
There are many possibilities to add a motion sensor to the Sprite®.
Small PIR motion sensors are available that use 5 Volt power and have a TTL voltage output.
These can be powered directly from the Sprite’s I/O port. Set the Sprite’s Control Mode to
Trigger High No Interrupt or Trigger High Delayed.
Wiring a 5 Volt motion sensor
We offer the MSA-B Stealth motion sensor for a plug-and-play solution.
Set the Sprite’s Control Mode to Trigger High No Interrupt.