35
UK
34
UK
4.2. Using a mains adapter
(optional accessory)
It is possible to operate this blood-pressure device
through a mains adapter (output 6 V DC / 600
mA with DIN plug). Use only original MEDEL
mains adapter.
a) Plug the DIN plug into the socket at the back
of the device.
b) Plug the mains adapter into a 230 V power
socket.
c) Test that power is available by opening the
flip.
Attention!
• No power is taken from the batteries while
the mains adapter is connected to the instru-
ment.
• If the mains voltage is interrupted during the
measurement (e.g. by removal of the mains
adapter from the mains socket), the device
must be reset by removing the DIN plug
from its socket.
• Please consult a specialist dealer if you have
questions relating to the mains adapter.
4.3. Tube connection
Insert the cuff tube into the opening provided on
the left side of the device, as shown in the picture.
4. PUTTING THE
BLOOD-PRESSURE MONITOR
INTO OPERATION
4.1. Inserting the batteries
After you have unpacked your device, first insert
the batteries. The battery compartment is located
on the underside of the device (see illustration).
a) Remove cover as illustrated.
b) Insert the batteries (4 x size AA 1,5V), the-
reby observing the indicated polarity.
c) Open the flip and press O/I button to turn
on the device.
d) If the battery warning appears in the dis-
play, the batteries are empty and must be
replaced by new ones.
Functional check: press O/I button to test all the
display elements. When functioning correctly, all
segments must appear.
Attention!
• After the battery warning appears, the devi-
ce is blocked until the batteries have been
replaced.
• Please use “AA” Long-Life or Alkaline 1.5V
Batteries.
The use of rechargeable batteries is not
recommended.
If the blood-pressure monitor is left unused for
long periods, please remove the batteries from the
device.
To Next Page
Loading...
