the nebulizer (pic. E).
6. Put the prescribed medication dose into the nebulizer (pic. F). The graduated scale can be
useful to control the correct medication quantity.
7. Close the nebulizer by turning the two parts in a clockwise direction, paying attention that
they are thoroughly sealed.
8. Connect one end of the air tube to the nebulizer (pic. G) and the other end to the air outlet
on the device (pic. A/4).
9. Use the MEDELJET PRO nebulizer with inhalation valve only with mouthpiece having exha-
lation valve. When using the masks or the nosepiece, it is not necessary to keep inhalation
valve: remove it (pic. B/16) and connect the nosepiece or the masks directly onto the nebu-
lizer (pic. I).
10. Plug the device to the wall socket, making sure that the electrical rating shown on the rating
plate on the bottom of the unit corresponds to your main voltage.
11. To start the treatment, switch the device on by pressing the switch (pic. A/2) in the front of
the device onto the “I” position.
12. Inhale the aerosol solution using the prescribed accessory.
13. When the treatment has been completed, switch the unit off by setting the switch position
“O” and disconnect the plug from the wall socket.
14. Wash the nebulizer and accessories as described in the “CLEANING AND DISINFECTION
OF THE ACCESSORIES” section.
15. Put the nebulizer, accessories and power cord inside the carrying case (pic. A/15).
CLEANING AND MAINTENANCE
CLEANING OF THE MAIN UNIT
Use a clean dry cloth and mild detergents for cleaning the unit.
ATTENTION: during cleaning operations, make sure liquids do not get
inside the device.
CLEANING AND DISINFECTION OF THE ACCESSORIES
After each treatment:
The nebulizer MEDELJETPRO, the mouthpiece and the nosepiece must be disinfected by boiling in
water (for max. 10 minutes) or in autoclave (max 121°C, see autoclave instructions for duration).
We suggest you disinfect the masks using cold disinfecting liquids (solutions with hypochlorite).
Dry the nebulizer using a clean cloth; after connect it to the air outlet (pic. A/4), switch the devi-
ce on and let it work freely for 5-10 minutes.
Do not boil nor autoclave the air tube and the masks.
Following carefully the cleaning and disinfecting instructions is very
important for the product performance and for a successful therapy.
14
UK
To Next Page
Loading...