Control History
The Precision PCx monitor can store up to 1,000 control tests that can
be retrieved by the following categories:
All Tests: This shows all control test results in memory starting with
the most recent test result in memory (reverse chronological order).
Operator ID: This shows the control test results that were performed
by a particular operator, starting with the most recent test.
Outside Range: This shows all the control test results that fell
outside of the acceptable ranges.
Comment Code: This shows all the control test results by comment
code.
Date: This shows the control test results performed on a specific
date, starting with the most recent test of the day.
Data Review for Control History for All Tests:
Please refer to page 5-2 of the Data Review section for the step-by-step
instructions to access the Data Review menu.
Note: If no information is stored for the desired category that was
selected, the following message will be displayed on the monitor:
“No Stored Tests”.
Note: If no tests match the criteria specified, this message will be
displayed on the monitor: “No Tests Match Request”.
If the monitor displays a message not indicated in these procedures,
please refer to section 10, Troubleshooting.
Questions? Refer to Page 10-13 For Customer Care Information.
5-15
What You See
on the Display
What You Do Comments
1. Press 2 – Control
History.
The Control History menu
now appears.
2. Press 1 – All Tests. The monitor shows the
result of the most recent
control test.
To Next Page
Loading...
