Questions? Refer to Page 10-13 For Customer Care Information.
5-19
Data Review for Control History by Outside Range Results:
Please refer to page 5-2 of the Data Review section for the step-by-step
instructions to access the Data Review menu.
Note: If no tests are stored for the desired category that was
selected, the following message will be displayed on the monitor:
“No Stored Tests”.
Note: If no tests match the criteria specified, this message will be
displayed on the monitor: “No Tests Match Request”.
If the monitor displays a message not indicated in these procedures,
please refer to section 10, Troubleshooting.
What You See
on the Display
What You Do Comments
1. Press 2 – Control
History.
The Control Test History
menu now appears.
2. Press 3 – Outside
Range.
The monitor shows the
most recent control test
result that is outside the
acceptable range.
To Next Page
Loading...
