8-14
Review/Change Test Setup for Patient Test:
Refer to the beginning of the Review or Change Setup section for
step-by-step instructions to access the appropriate setup menu.
If the monitor displays a message not indicated in these procedures,
please refer to section 10, Troubleshooting.
What You See
on the Display
What You Do Comments
1. Press 1 – Test Setup. The display shows the
Test Setup menu.
2. Press 2 – Patient Test. The display shows the
Patient Test, Patient ID
Barcode screen.
3. The administrator will
select one of the
following options:
Press 1 –
Next; skip
forward to step 14.
Press 2
– Change; to
change Patient ID.
The display shows the
Patient ID options.
4. The administrator will
select one of the
following options:
Press 1 –
Disabled;
(returns to the previous
screen).
Press 2
– Optional.
Press 3 – Required.
If Disabled is selected, the
display will not prompt
for Patient ID. If Optional
or Required is selected,
the operator can enter a
minimum and maximum
number of digits, between
1-15 digits.
To Next Page
Loading...
