Medivators DSD-201 - Page 182

174
MM03-0047
Revision
D
REPROCESSING SYSTEMS
"Res T Low” is displayed.
Incorrect reservoir controller temperature .......... Adjust to correct temperature.
Incorrect program temperature setting................ Use Diagnostics 74 to enter value.
Thermistor defective ........................ n Repair or replace the component.
Heater turned off or defective ............................. Turn heater on or replace. Check harness
connection.
“Sheath Fail” is displayed (for optional leak tester only).
Large leak detected at beginning of cycle........... Leak in scope. Allow the scope to reprocess,
then remove scope and send for repair.
Leak between connectors. Press STOP to cancel
the cycle and open the lid locks. Check connec-
tion and reprocess scope.
Small leak detected during cycle ........................ Leak in scope. Allow the scope to reprocess,
then remove and manually leak test the scope.
Leak test adapter not connected.......................... Press STOP to cancel the cycle and open the lid
locks. Connect correct leak test adapter and
reprocess scope.
Leak tester harness disconnected/defective ........ Check the leak tester harness connection.
Replace a defective harness.
Leak tester board defective.................................. Replace the leak tester board.
Leak tester assembly defective ........................... Replace the leak tester assembly.
"Shth Sen Err” is displayed during initial start (for optional leak tester only).
Scope is pressurized during startup .................... Press STOP to cancel the cycle and open the lid
locks. Disconnect the leak tester hook-up to
release the pressure. Reconnect the hook-up.
Leak tester enabled, but option not present ........ Use Diagnostic 45 to disable leak tester option.
Leak tester board defective ................................. Replace the leak tester board.
Leak tester defective ...................... Replace the leak tester.