Medivators DSD-201 - Page 208

£ MEDIVATORS'
2" REPROCESSING SYSTEMS
DSD-201 Endoscope Reprocessor Diagnostic Functions
51 Activate sheath valve 76 —not used--
52 Activate leak test compressor valve 77 --not used--
53 Activate leak test compressor 78 —not used--
54 Tum off all valves and reset latches 79 Enable AII Sensors
55 Turn off sheath compressor 80 Set language
56 Activate sheath test 81 Set time limit
57 Activate sheath hold 82 Set serial number
58 --not used-- 83 Program low flash
59
--not used-- 84 Program high flash а:
60 Set default program 85 Program entire flash - в ИНО van
61 Set rinse and disinfectant drain times . 86 Initialize NVRAM πως | 同
62 Set rinse and disinfectant fill times 87 Disable all sensors i
63 Set fluid and air purge timse 88 Set options o
64 Set disinfectant pulse time 89 Set station idle “ à
65 Set add air time 90 Display inputs LUE vi
66 | Set partial rinse fill and drain times 91 | Display cycle count” i” | Sc Ee
67 Set rinse and disinfectant top-off times 92 -not used- | ~ TE
68 | Setre-circulation rinse time 93 | Display temps Y σα
69 Set automatic disinfect hold time 94 Test sensors Ἱ. m ，
70 Reset system alarm 95 Test sheath tester | _
71 Set maximum disinfectant cycle count -.. 96 | --not used-- i ' ° i
72 Reset programs E 97 Znot used- и
73 Clear disinfectant counter 98 --not used--
74 Set maximum reservoir temp 99 --not used--
75 Set minimum basin temp
A-26 MM03-0047 Revision D