6
OPERATION INSTRUCTIONS
1. Place compressor on a stable, sturdy and flat surface such that the unit can
be easily reached when you’re seated.
2. Make sure the compressor is off by pressing the power switch to the “OFF”
(O) position.
3. Plug power cord into a wall outlet.
4. Connect one end of the tubing into the compressor air outlet connector.
5. Add the prescribed solution through the opening on jet nebulizer cap using
an eye dropper or pre-measured dose container.
6. Assemble mouthpiece onto the top of the jet nebulizer cap. If an aerosol
mask is used, connect the bottom of mask to the top of jet nebulizer cap.
7. Connect tubing to jet nebulizer air inlet connector.
8. Turn the compressor on by pressing power switch to “ON” (I) position.
9. Implement the treatment by placing the mouthpiece between the teeth.
Inhale and exhale through the mouthpiece.
10. If an aerosol mask is used, place the mask over the mouth and nose.
Note: The compressor motor has a thermal protector which will shut off the
unit before the unit overheats. When the thermal protector shuts the unit off:
1) Switch off the unit, 2) Unplug the unit from the electrical outlet, 3) Wait 30
minutes for the motor to cool down before another treatment.
To Next Page
Loading...
