10
SETTING DATE AND TIME
The device displays time and date on the LCD. They can be set according to the following method:
1. Make sure the machine is powered OFF, then hold the SET button for 5 seconds until digits on the screen
start flashing.
2. Press the SET button to switch between month, date, hour and minute.
3. Press the MEM (Memory) button to advance the display selected by one digit at a time.
4. When the unit is powered off, the clock will continue to display on the LCD screen.
SETTING TALKING FEATURE
For the MDS5001, after the date and time settings are selected, the "SP" character will flash.
Press the MEM (Memory) button to move from English, "SP 01", to Spanish, "SP 02", or to off, "SP OF".
MEMORY FUNCTION
Memory Input
When a valid measurement is made, the result (systolic, diastolic, pulse rate, date and time) will be
stored in the memory automatically as soon as the device is turned off or when another measurement is
initiated. The device can store up to 90 readings for each of 2 users, and also compute the average of the
latest 3 readings. When more than 90 readings are stored, the oldest ones will be replaced.
Memory Recall
By pressing Memory button, AVG will be shown in the lower left hand corner. AVG means the average of all
recorded readings. Press the Memory button again and 01 will appear in the lower right hand corner, which
is your latest reading in the memory. When you press Memory again, 02 will display which is the previous
reading. When you press the Memory button repeatedly, the records will be displayed sequentially, along
with the corresponding date of the measurement.
To Next Page
Loading...
Need help?
General
