To determine proper height, stand upright behind the
rollator with shoulders relaxed, arms hanging at your side
and eyes looking straight ahead. Standing in current
position, the hand grips (A) of the rollator should be adjusted
to a height even with the wrists. This will position the arms
at an approximated 20 to 30 degree bend when using the
rollator. Secure the wheels to the closest hole to the
desired height. Insert and tighten the triangular hand
screws until secure. (Important: Hand Tighten Only!)
Hole 1 Hole 2 Hole 3 Hole 4
Hole 1
29 1/4" 30 1/4" 31" 32"
Hole 2
30 1/2" 31 1/4" 32" 32 3/4"
Hole 3
31 1/4" 32" 32 3/4" 33 1/2"
Hole 4
32" 33" 33 3/4" 34 1/2"
Hole 5
32 3/4" 33 1/2" 34 1/2" 35 1/4"
Hole 6
33 3/4" 34 1/2" 35 1/4" 36 1/4"
9
Brake Handle Assembly
1. Insert hand grip into appropriate hole (see Figure A and chart below).
Note: Keep brake cable on outside of rollator.
2. Insert triangular hand screw into hole on outside of rollator frame (see Figure B).
(Important: Insert hand screw into one of the 4 holes provided.
DO NOT put hand screw in open slot at end of hand grip!)
3. Hand tighten screw until secure (see Figure C). (Important: Hand Tighten Only!)
4. Repeat steps 1-4 for other hand grip.
Ultra-Light Rollator Hole Measurements:
Arm Height
Leg
Height
Figure CFigure BFigure A
Seat height adjustable
from 19 1/4" to 23 1/4"
Handle height adjustable
from 29 1/4" to 36 1/4"
To Next Page
Loading...
Need help?
General
