LSUHSC Shreveport
Radiology Department
Proc 13.17
DISPLAY CONSOLE KEYS
1. SETUP – identifies configurable items and displays values.
2. HELP – information on system operation and service.
3. RESET- replaces all programmed phases, with factory default settings.
SYSTEM MALFUNCTION MESSAGES
If a system malfunction appears:
a. Immediately remove power and disconnect the patient from the
system.
b. If a fault message cannot be corrected, and/or the system is not
Operating properly, DO NOT USE the system. Call MEDRAD
Service.
c. Routine inspections and maintenance will ensure continued
performance and reduce equipment malfunction. MEDRAD, Inc.
recommends complete calibration and performance check annually.
CLEANUP
1. SHOCK HAZARD. Disconnect the system from line power when
cleaning.
2. Do not immerse any part of the injector or allow liquid to enter the
enclosure.
3. Wipe the system with a soft cloth, warm water and a mild disinfectant.
For all body-fluid spills, follow institutional decontamination procedures.
To Next Page
Loading...
