10
2.8 Parameter Mode
The thermometer has four parameters that can be tailored to certain populations or environmental
conditions.
Entering Parameter Mode
• Ensure the thermometer is on.
• Press and hold the Set Button until “F1” and then “Unit” is displayed
.
Temperature Units (F1)
The thermometer can be set to display the temperature in Fahrenheit or Celsius.
• Press either the Memo Button or the Mode Button to toggle between Fahrenheit and Celsius.
• When the desired units have been selected, press the Set Button to move to the next parameter.
Fever Threshold (F2)
The thermometer allows the fever threshold to be modified. This is the value at which the thermometer
will indicate a slight fever. The default value is 100.5 °F.
• The threshold value will be displayed as it is modified.
• Press the Memo Button to increase the threshold by approximately 0.2 °F (0.1 °C).
• Press the Mode Button to decrease the threshold by approximately 0.2 °F (0.1 °C).
• When the desired threshold has been selected, press the Set Button to move to the next
parameter.
Audio (F3)
The thermometer can be used with audio enabled or disabled.
• Press either the Memo Button or the Mode Button to toggle between audio enabled and audio
disabled.
• When the desired audio setting has been selected, press the Set Button to move to the final
parameter.
Note: The audio can also be enabled and disabled via Set Button when not in Parameter Mode.
o The units (°F or °C).
o Whether body or surface temperature.
o For body temperature, a happy or sad face icon
• Every stored measurement will be displayed with a green backlight.
• To clear the stored values, press and hold the Memory Button until “Clr” is displayed.
• Empty memory cells will be displayed with “ - - - -“ as the temperature value.
To Next Page
Loading...
