MedSource MS-131002 - Operational Notes

11
Temperature Oset (F4)
The thermometer allows a surface temperature oset to be entered. This will increase or decrease the
displayed surface temperature, based on the oset value. The default oset value is zero. The oset
range is ± 9.0 °F (± 5.0 °C).
• The oset value is displayed as it is modified.
• Press the Memo Button to increase the oset by approximately 0.2 °F (0.1 °C).
• Press the Mode Button to decrease the oset by approximately 0.2 °F (0.1 °C).
• When the desired temperature oset has been selected, press the Set Button to exit Parameter
Mode.
2.9 Notes
• If you experience problems with this thermometer, such as configuration, maintenance or use,
please contact the SERVICE PERSONNEL. Do not attempt to open or repair the device
yourself.
• Please report to us any unexpected operation or events.
• The patient is an intended operator. They can determine the state of the batteries and change
the batteries. The patient can maintain the device and its accessories according to the user
manual under normal circumstances.