Meec tools 004907 - Storage and Transport; Long Term Storage

EN
49
• The height of the rakers should be checked
after 3 – 4 lings. If necessary, le down the
rakers with a le template and at le.
BAR
• Turn the bar round every 8 working hours
to ensure that it wears uniformly.
• Use a cleaning tool to keep the slot and
lubrication holes clean.
• Check the bar at regular intervals for wear
and damage, and replace if necessary.
• Clean the oil channels on the bar to ensure
proper lubrication of the bar and chain.
WARNING!
Never t a new chain on a worn sprocket or
worn guide ring.
STORAGE AND TRANSPORT
Long-term storage
• Store the chain saw out of reach of
unauthorised persons.
• Allow the chain saw to cool before putting
away.
• Store the chain saw horizontally.
• Remove the chain if the saw is not going to
be used for a long time.
• Store the chain saw in a dry place.
Transport
Follow the instructions below when transporting
in a vehicle:
– Make sure the guard is tted over the
bar.
– Secure the chain saw so that it cannot
move.
– If possible, transport the chain saw in
its original pack.