52
FITTING BITS
/
DRILLS
1. Open the quick chuck by turning the front part. Hold the back part of the quick chuck and
turn the front part.
2. Insert the bit/drill into the chuck until it stops.
– Use an adapter for screw bits.
– Use suitable screw bits for the screws.
3. Hold the back part of the quick chuck and turn the front part to lock.
Check that the bit/drill is locked in place.
ROTATION SELECTOR
NOTE: Do not touch the rotation selector when the drill driver is moving.
Back of chuck
Lock
Open
Front of chuck
Rotation selector
To Next Page
Loading...
