ENGLISH
Limbing
Limbing is the process of removing branches from a
felled tree. Do not remove bearing branches (A) until the
tree is cut into lengths.
Tensioned branches must be cut from below, so that the
chain saw does not get caught.
Never stand on the trunk when cutting off branches!
Cross-cutting
Cross-cutting is sawing a felled tree into lengths. Make sure you have a firm footing and stand uphill of
the tree when working on slopes. If possible, the trunk should be supported so that the end to be cut is
not resting against the ground. If the log is supported at both ends and you need to cut in the middle,
make a downward cut halfway through the stem and then a bottom cut. This prevents the bar and chain
from getting caught. Be careful so that the tip of the bar does not enter the ground when cutting, as the
chain will become dull quickly. Always stand uphill of the tree when cutting on slopes.
Log supported along entire length: Cut from the top (top
cut). Be careful not to cut into the ground.
Log supported at one end: First cut one third of the
diameter from below (bottom cut) to prevent splitting.
Then saw from above (top cut) to meet the first cut and
avoid the bar being clamped.
Log supported at both ends: First top cut one third of the
diameter to prevent splitting. Then bottom cut to meet the
first cut and avoid the bar being clamped.
53
To Next Page
Loading...
