Megasat HD 660 Twin - User Manual

Questions and Answers

T
thomas12Aug 9, 2025
Why is there no picture or sound on my Megasat Receiver?
- S
  Sean GarciaAug 9, 2025
  If you're not getting any picture or sound on your Megasat Receiver, it could be due to a few reasons. First, the dish might not be correctly aligned to the satellite, resulting in a weak or no signal. You should check the dish's alignment to ensure a better signal, using the signal strength submenu. Also, the LNB or coaxial cable could be defective, so check the connection from the LNB to the receiver, replacing components if needed. Finally, make sure you're on the correct TV channel (AV or HDMI).
T
Tara JohnsonAug 13, 2025
What to do if the Megasat HD 660 Twin remote control does not work?
- B
  benjamin01Aug 13, 2025
  If your Megasat Receiver's remote control isn't working, the batteries might be empty. Try replacing them. Also, make sure there isn't anything blocking the path between the remote control and the receiver, as obstacles can reduce reception.
M
Michael HortonAug 18, 2025
What to do if I forgot my Megasat HD 660 Twin Receiver password?
- J
  jessica90Aug 18, 2025
  The default password for your Megasat Receiver is 0000. If this doesn't work, the password has likely been changed. Contact your dealer for assistance.
C
Collin MaynardAug 23, 2025
How to fix a bad, jerky picture on my Megasat HD 660 Twin?
- S
  sonia07Aug 23, 2025
  A bad, jerky picture on your Megasat Receiver can be caused by several factors. The dish may not be pointing precisely at the satellite, the signal might be too strong, the dish could be too small, or the LNB's noise figure might be too high. Here are some possible solutions: * Adjust the dish correctly. * Use a damping controller if the signal is too strong. * Consider using a larger dish. * Change the LNB.
R
Rick PerryAug 29, 2025
Why is there no start screen when starting the Megasat Receiver?
- V
  Victor LeonardAug 29, 2025
  If you're not seeing the start screen when you turn on your Megasat Receiver, and it's connected via HDMI, make sure your TV is set to the correct HDMI mode (e.g., HDMI 1).
C
cameronterriSep 2, 2025
How to fix Megasat HD 660 Twin Receiver when the LED light does not light up?
- L
  Lisa HallSep 2, 2025
  If the LED light on your Megasat Receiver isn't lighting up, it might be because the power cord isn't connected properly. Check that the power cord is securely connected.

Megasat HD 660 Twin Specifications

General

Tuner Type	DVB-S2
Video Resolution	1080p
Number of Tuners	2
Recording Functionality	Yes
Type	Satellite Receiver
HDTV compatible	Yes
Video Decoder	MPEG-2, MPEG-4, H.264
Ethernet	No
CI Slot	1
Connectivity	HDMI, USB
Audio Decoder	AAC