Need help?Do you have a question about the Megger frax 150 and is the answer not in the manual?
General| Output Voltage | Up to 10 V peak |
|---|---|
| Accuracy | ±0.1 dB amplitude, ±0.1° phase |
| Interfaces | USB, Ethernet |
| Power Supply | 100-240 V AC, 50/60 Hz |
| Type | Sweep Frequency Response Analyzer |
| Frequency Range | 0.1 Hz to 15 MHz |
| Display | LCD |
Essential safety precautions and guidelines for operating the FRAX instrument safely.
Detailed technical parameters and specifications of the FRAX analyzer.
Description of the front and rear panels of FRAX-101 and FRAX-150 instruments.
Explanation of the Sweep Frequency Response (SFRA) measurement principle and technique.
Crucial safety instructions for beginners using the FRAX instrument and software.
Guidance on powering on the FRAX and establishing communication via USB or Bluetooth.
Detailed instructions on connecting the FRAX test leads and clamps for accurate measurements.
Methods for verifying the integrity and correct operation of the FRAX test system.
Steps to initiate a measurement sweep after setting up the test.
Minimum system requirements for installing and running the FRAX software on a PC.
Step-by-step guide for performing automated calibration of the FRAX unit.
To Next Page
