Need help?Do you have a question about the Megger LTW315 and is the answer not in the manual?
Explains instrument symbols for safety and compliance.
Details on connecting the instrument's test leads for various tests.
Details the no-trip test method for RCD-protected circuits.
Step-by-step guide for no-trip tests using the mains socket lead.
Procedure for performing a high current phase-to-earth loop test.
How to measure voltage and frequency for phase-to-earth/neutral.
Explains conditions that stop or prevent loop tests from running.
Step-by-step guide for safely replacing the instrument's batteries.
Provides general technical data, ranges, and accuracy for the instrument.
Contact information and procedures for instrument service and parts.
Explains instrument symbols for safety and compliance.
Details on connecting the instrument's test leads for various tests.
Details the no-trip test method for RCD-protected circuits.
Step-by-step guide for no-trip tests using the mains socket lead.
Procedure for performing a high current phase-to-earth loop test.
How to measure voltage and frequency for phase-to-earth/neutral.
Explains conditions that stop or prevent loop tests from running.
Step-by-step guide for safely replacing the instrument's batteries.
Provides general technical data, ranges, and accuracy for the instrument.
Contact information and procedures for instrument service and parts.
General| Display | LCD |
|---|---|
| Continuity resolution | 0.01Ω |
| Frequency | 50/60 Hz |
| Type | Loop Impedance/Continuity Tester |
| Continuity range | 0.01 Ω to 2000 Ω |
| Loop impedance range | 0.1 Ω to 2000 Ω |
| PSC range | 1A to 20kA |
| Accuracy | ±2% ±2 digits |
| Power Supply | Battery |
| Dimensions | 200 x 100 x 50 mm |
| Safety Standards | EN61010-1, EN61557 |
To Next Page
