Meister EF600M - Scope of Delivery; Technical Information; Noise Emission and Information

1 – Scope of delivery
• Slab&TileCutter
• Protectivehood
• Angledstop
• Parallelstop
• Waterreservoir
• 2xTool
• 1xDiamondcuttingdisc
• Instructionmanual
• Guarantee
2 – Technical information
Technical data
Powersupply 230V~/50Hz
Nominalpower
requirement 600W/S2:10min
Protectiontype IPX4
Idlingspeed(rpm) n
0
:2950min
–1
Worksupportplate 330x360mm
Diamondcuttingwheel Ø180
Bladelocationhole 25,4mm
Max.cuttingdepth 34mm
Lead 200cm
Protectionclass I
Technicalchangesreserved.
Noise emission
L
pA
:92,0dB(A),L
WA
:105,0dB(A)
Measuringinaccuracy:
K
pA
:3,0dB(A),K
WA
:3,0dB(A)
Noise information
Measuredvaluesdeterminedin
accordancewithEN61029-1.
CAUTION! A certain amount of
noise is unavoidable when using
this device. Ensure you carry out
noise-intensive work during permitted
times. Maintain the quiet periods and
limit your work to the absolute
minimum.

may cause damage to your
hearing. Only ever work with suitable
ear defenders. Anybody else in the
vicinity should thus also wear ear
defenders.
Operating instructions & safety hints
WARNING! To reduce the risk of injury, please read the operating instruc-
tions through carefully before using the device, and then store with the
machine! When passing the device on to another user, these operating inst-
ructions must also be included!
GB

1 – Scope of delivery 30
2 – Technical information 30
3 – Components 31
4 – Correct use 31
5 – General safety instructions
for handling power tools 32
6 – Safety instructions

the equipment 34

7 – Installation and setting 35
8 – Operation 36
9 – Mode of operation 36
10 – Maintenance and
environmental
protection 36
11 – Service instructions 37
Contents
30
MW-5461060-Bedien-2005.indd 30MW-5461060-Bedien-2005.indd 30 13.05.20 11:0213.05.20 11:02