EasyManua.ls Logo

Meister EF600M - Operation; Mode of Operation; Cutting Tiles; Maintenance and Environmental Protection

Meister EF600M
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
screws(6)totherightandleftofthe
workplate.Setthemitreanddoupthe
screws.
8 – Operation
Theunitisprovidedwitharesidual
currentcircuit-breakerintegratedin
themainsplug(Fig.4),whichprevents
themotorfromstartinguncontrolled
whenputtingintooperation,afterpower
failureorshort-circuit.
• Inserttheplugintoapowersocket.

operation, a functional test must
always be conducted:

integrated residual current safety
fuse must be able to be audibly
deactivated.

The integrated residual current
safety fuse must be able to be
audibly activate.
ATTENTION! As soon as the
residual current safety fuse is
activated, the pilot lamp (L) comes on.
It goes out with a short-circuit, power
failure or when the mains plug is
pulled.
ATTENTION! Without prior
functional test, the unit cannot
be switched on! Only after the
functional test has been conducted is
the unit ready for operation.
Activate the green button on the
residual current circuit breaker.
• Toswitchon:PressOn/Oswitch(8)
to(l).
• Toswitcho:PressOn/Oswitch(8)
to(O).
ATTENTION! With any functional
disturbance or shutdown, press

„0“ to prevent the motor from starting
uncontrolled.
9 – Mode of operation
Cutting tiles
Cutwiththedecoratedsideupward.
Alwaysusealightbutevenpressurewhen
pressingthework-pieceagainsttheblade
edge,eveniftheresistanceincreases.
S2 :10 min
Donotrunthetoolforlong
periodsatatime.Toavoid
overheatingthetoolshouldnotbekept
switchedonforlongerthan10minutesat
atime.Allowthetooltocooldown
betweenwhiles.
10 – Maintenance and
environmental
protection

Afterusecleanthetoolwithadamp
clothonly.Emptyandcleanthewater
reservoir.Treatnon-stainlesspartswith
ananti-corrosiveagent.
CAUTION! Electrical and battery
operated units that no longer work
should not be disposed of in the house-
hold waste! They are to be collected
separately, in accordance
36
MW-5461060-Bedien-2005.indd 36MW-5461060-Bedien-2005.indd 36 13.05.20 11:0213.05.20 11:02

Other manuals for Meister EF600M