Meister EF600M - Installation and Setting; Selecting and Replacing Cutting Wheel; Using the Parallel Stop; Using the Angle Stop

Donotdisposeofwiththe
householdwaste!
Important!Observethe
operatinginstructions!
Weargoggles.
Wearadustprotectionmask.
Weareardefenders.
ProtectionclassI
Voluntary“geprüfteSicherheit”
sealofquality(testedsafety)
CEmark(conformitywith
Europeansafetystandards)
Machineweight
Max. cutting depth
BJ Yearofconstruction
SN: Serialnumber
SN:XXXXX Thersttwounderlined
numbersgivethemonthof
manufacture.
7 – Installation and setting
Selecting and replacing the diamond
cutting wheel

Removethewaterreservoir(7)andthe
plasticcoverhood(14)(Figure2).Undothe
outerhexagonalscrew.Removetheange
andreplacethediamondcuttingdisc(2)
(Fig.3).Reassembleinthereverseorder.
WARNING! Make sure that the
arrow showing the direction of
rotation on the new cutting wheel
points in the same direction as the
arrow on the protective hood on the
work plate.

diamond cutting discs.
Check the ring cutter
for hairline cracks
and deformation
before using, and, if
necessary, replace
the disc. Always use
suitable diamond discs for wet
cutting. The choice of disc depends
on the material to be cut, so always
follow the maker’s instructions.

Theparallelstop(10)enablescutsto
bemadelengthwaysalongthework-
piece.Forthissimplysetatthedesired
distancefromthecuttingdisc,usingthe
scaleforparallelcuts(3).
Angle stop
Forthissecuretheparallelstop(10)on
theothersideofthecuttingwheeland
settheanglestop(11)ontherail.
Mitre setting
Theadjustableworkplate
enablesmitredcutsatangles
ofupto45otobemade.To
obtainthedesiredmitreundothetwo
35
MW-5461060-Bedien-2005.indd 35MW-5461060-Bedien-2005.indd 35 13.05.20 11:0213.05.20 11:02