Meister EF600M - Safety Instructions Relating Specifically to the Equipment; Safety Marking

persons unfamiliar with the power
tool or these instructions to operate
the power tool. Powertoolsaredanger-
ousinthehandsofuntrainedusers.
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any

power tool’s operation. If damaged,
have the power tool repaired before
use. Manyaccidentsarecausedby
poorlymaintainedpowertools.
f Keep cutting tools sharp and clean.
Properlymaintainedcuttingtoolswith
sharpcuttingedgesarelesslikelyto
bindandareeasiertocontrol.
g Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Useofthepowertoolfor
operationsdierentfromthoseintended
couldresultinahazardoussituation.
5 Service
a Have your power tool serviced

only identical replacement parts.
Thiswillensurethatthesafetyofthe
powertoolismaintained.
b Toavoidhazards,damagedpower
leadsmustbereplacedbythe
manufacturerorhiscustomerservice
representative.
6 – Safety instructions

the equipment
• Wearprotectivegogglesandgloves
and,ifnecessary,earprotectorsand
breathingmask.
• Alwaysxthetooldownsecurelyon
anevensurface,ifnecessary,using
clampingxtures.
•
Neverfeedthework-piecetobe
machinedtothetoolbyhand!Usefor
thiseitherasmallpieceofwoodorthe
plasticguideblocksuppliedwiththe
tool.
• Neverusecrackedorsegmentedsaw
blades.
• Beforestartingworkalwayscheckthe
waterlevelinthecoolingwaterreservoir
and,ifnecessary,llortopitupwith
water.Ifcuttingforlongerperiods,
checkthewaterlevelfromtimetotime.
• Beforestartingworkallowthecutting
wheeltoreachtherequiredspeed.
• Afterswitchingowaitforthecutting
wheeltostoprotating.NEVERTRY
TOBRAKEIT!
• Alwaysensurethattheprotective
hood(1)isttedandcanmovefreely.
• Replacefaultyprotectivehoods
immediately.
• Donotstandinalinewiththecutting
bladeinfrontofthemachine.Always
standasideofthesawblade.This
protectsyourbodyagainstpossible
kickback.
• Keephands,ngersandarmsaway
fromtherotatingcuttingblade.
• Determinethecauseoftheblockage
andeliminateit.
Safety marking
Thesymbolsonthehousingmeanthe
following:
34
MW-5461060-Bedien-2005.indd 34MW-5461060-Bedien-2005.indd 34 13.05.20 11:0213.05.20 11:02