meitav-tec MTS/V50 - P7 Enable;Disable the Beeper; Exit Technician Settings and Return to Normal Display

16 pages

To Next Page

To Previous Page

-15 -

Important! Reset the set-point temperature to the desired value

Press the button to

return to parameter P1.

Press the button or

wait 60 seconds to exit

technician settings mode

and return to normal display.

(Advance)(Return)

5. Technician settings (cont’)

P7 Enable/Disable the beeper

Using the and buttons,

select between:

0 – Disable the beeper

1 – Make the panel beep

whenever a button is pressed