6 Maintenance
19
6 Maintenance
u Switch off the label printer and pull the power plug before cleaning and/or maintenance.
u Do not use any solvents such as benzine or acetone.
u Should you use cleaning alcohol, wait until it has evaporated entirely before closing the housing cover.
Routine maintenance
Routine maintenance should be performed monthly and comprises cleaning of the following components:
Print head and print roller
Clean the print head and print roller as follows.
1. Open the upper housing cover.
2. Remove any soiling such as dust and stains from the print head or printer roller.
Use a soft, non-fuzzing cotton cloth.
3. Close the housing cover after cleaning.
Paper sensor
Clean the paper sensors as follows:
1. Open the upper housing cover.
2. Remove any soiling such as dust and stains from the sensors.
Use a soft, non-fuzzing cotton cloth and pure alcohol.
3. Wait until the alcohol has evaporated completely and then close the housing cover.
To Next Page
Loading...