Meler 200-ST Series User Manual

4
TABLE OF CONTENTS Page
• Introduction III. 3
• Supplies and running environment and siting conditions required for
the installation of the Central Unit Applicators III. 3
• Fittings and Accessories supplied by with the Central Units III. 3
• Other equipment required for installation III. 3
• Tools required for installation III. 4
• Operating environment III. 4
• Siting conditions for the Central Units III. 4
• Dimensions and weights of the Series 200-ST Central Units III. 5
• Assembly and hookup for the Central Units and their accessories III. 6
• Electrical power supply for the Central Unit Applicators III. 6
• Maximum system power requirement, according to electrical supply type III. 6
• Air supply for the Central Unit Applicators III. 7
• Hookup terminal for the Series 200-ST Central Unit Applicators III. 7
• Accessories hookup for the Series 200-ST Central Unit Applicators III. 8
• Gun Installation III. 8
• Installation of the hoses and hookups between Central Units - hoses - guns III. 8
• Installation of the Accessories for the Series 200-ST Central Unit Applicators III. 9
• Single-acting guns III. 9
• Double-acting guns III. 9
• Installation of peripheral control leads III. 10
• Installation of the input electrical power at external power supply to Parent
Machine Interlock, and remote activation of standby III. 11
• Installation of remote activation of "standby" III. 11
Fig. 5 Guarantee card III. 2
Fig. 6 Dimensions and weight of ML-200-ST model III. 5
Fig. 7 Electrical wiring connections III. 6
Fig. 8 Series 200-ST Central Unit Applicators control
board diagram III. 7
Fig. 9 Installation of guns III. 8
Fig. 10 Hose hookup to Applicator Central Unit III. 8
Fig. 11 Electrical wiring of Solenoid Valve 3/2 III. 8
Fig. 12 Pneumatic hookup of Solenoid valve 3/2 III. 8
Fig. 13 Electrical wiring of Solenoid valve 4/2 III. 8
Fig. 14 Pneumatic hookup of Solenoid Valve 4/2 III. 9
Fig. 15 Installation of peripheral control leads III. 10
Fig. 16 Installation of the input electrical power at external power
supply to Parent Machine and remote activation of "standby" III. 11
• INSTALLATION MANUAL FOR THE CENTRAL UNIT APPLICATORS

Meler 200-ST Series Specifications

General

Brand	Meler
Model	200-ST Series
Category	Industrial Equipment
Language	English