TABLE OF CONTENTS Page
• ON/OFF switch for the ML-200--ST Central Unit Applicator II. 3
• Temperature display and modification, and manual activation of standby II. 3
• Temperature display and adjustment II. 3
• ON/OFF operation of standby II. 4
• Program timer, daily automatic ON/OFF function and daily start-up and
shutdown of standby II. 4
• Data Information II. 4
• Function operation II. 4
• LED functions II. 5
• Programming in "CLOCK" mode II. 5
• Time set to present hour and day II. 5
• Program set for automatic connect and disconnect timer II. 6
• Program set for automatic activate and deactivate standby timer II. 6
• Breakdown, overheating or sensor breakage signal II. 6
• Overheating II. 6
• Temperature sensor breakage II. 7
• Alarm system hot-melt level too low in tank (optional) II. 7
• Gas flow regulator system (optional) II. 7
Fig. 2
Main for general protection II. 3
Fig. 3
ON/OFF switch II. 3
Fig. 4
Temperature readout and adjustment II. 3
3
TABLE OF CONTENTS Page
• Safety summary I. 2
• Technical specifications of the Series ML-200-ST Central Unit Applicator I. 2
• Brief description of how to use this manual I. 4
• Front control panel description for Series ML-200-ST Central Unit Applicator I. 4
Fig. 1
Control Panel for the Central Unit Applicator I. 4
• INTRODUCTION TO THE SERIES ML – 200- ST CENTRAL UNIT APPLICATOR
••
OPERATING INSTRUCTIONS FOR THE ML-200-ST CENTRAL UNIT APPLICATOR
To Next Page
Loading...
Need help?
General
