TABLE OF CONTENTS Page
• Introduction V. 3
• Temperatures V. 3
• Electrical supply V. 3
• Air pressure supply V. 3
• General cleaning and yearly servicing of the Central Unit V. 3
• General cleaning V. 3
• Tank cleaning V. 3
• Tank drainage V. 4
• Cleaning of hydraulic circuit and hoses V. 4
• Cleaning guns and nozzles V. 4
• Filter change V. 4
• Pump filter change V. 5
• Pump filter mesh change V. 5
• Complete pump filter change V. 5
• Tank input filter change V. 6
• Inline filter change V. 6
• Bogging control for Hot-Melt V. 6
• Spare parts V. 7
• Electrical diagram of connections wiring V. 19
• Electrical diagram Series 200-ST Central Unit Applicators V. 20/21/22/23
Fig. 17
Pressure adjustment gauge V.3
Fig. 18
Tank drainage components V.3
Fig. 19
Pump filter set V.4
Fig. 20
Inlet filter set V.5
Fig. 21
Disassembly of inline filters V.5
• C.U APPLICATOR SERIES 200-ST-ND
TABLE OF CONTENTS Page
• Spare parts compatible unit ML-200-ST-ND A. 2
• Electrical diagram C.U. Applicator series 200-ST-ND A.3 / 4 / 5 / 6
6
• MAINTENANCE FOR THE CENTRAL UNIT APPLICATORS
To Next Page
Loading...
Need help?
General
