For any future activation of the remote control, it is advisable to extract and note the code in use, operate as follows:
• On the MELICONI remote control press and hold the button until the LED lights up; release.
• Enter the code 0010.
• After a pause of several seconds, the LED produces four sets of flashes, spaced out,
corresponding to the code to be obtained. Count the number of flashes. Each set of flashes
corresponds to one digit in the code. Ten flashes correspond to the digit zero “0”.
(example code obtained = 1701)
• Make a note of the code obtained. You may need it in future.
If you want to delete the function in combination with a single button, operate as follows:
• On the MELICONI remote control press and hold the button.
• When the LED turn on, without releasing the button, enter the code 1600; release the buttons.
• Within 30 seconds, press and hold the button of which you want to delete the function; wait three flashes indicating the end
of the operation, release the button. (to recall the original function, setting again the activation code)
If necessary it is possible to completely reset the remote control and bring it back to the initial conditions.
WARNING : All user settings will be lost. Operate as follows:
• On the MELICONI remote control press and hold the button until the LED lights up; release.
• Enter the code 0100.
• Three final flashes indicate that the operation has been completed successfully.
web: www.cme.it e-mail: telecomandi@meliconi.com
IMPORTANT! To obtain technical assistance, it is essential to indicate the BRAND and MODEL of the appliance you intend
to control and the name of the MELICONI remote control you are using.
WARRANTY: 2 year Always keep your sales receipt as proof of the validity of the product’s warranty. The warranty is
voided if the product is tampered with or used improperly.
DELETE FUNCTION BY SINGLE BUTTON
To Next Page