MELICONI Fully 8 RC User Manual

INSERTING THE BATTERIES
The remote control requires 2 new 1.5V alkaline AAA/LR03 batteries.
Insert them as illustrated.
Try pressing a number button and check that the red light remains lit
continuously until you release the button: if the light fl ashes, the batteri-
es inserted are not charged and are about to go fl at, therefore you must
substitute them.
Do not leave fl at batteries inserted, as liquid may leak and damage the remote control
The Fully 8 RC remote control is a universal remote, so its memory contains data relating to numerous devices of various
brands available on the market.
Each original device has a specifi c code which must be used to set up the remote control.
Therefore, to use your Fully 8 RC you must enter the specifi c code for each device you wish to control.
So use one of the following methods to identify the correct code and set it in your remote control:
A) - INTERNET (recommended)
B) - CELL PHONE (SMS)
C) - MANUAL SEARCH
SETTING CODES
If you have an Internet connection available, follow the on-line guide on the www.meliconi.com/guida website to identify
the specifi c codes for the devices you wish to command. Then set the codes manually in your MELICONI remote control
as described in the ENTERING THE CODE DIRECTLY procedure.
SETTING CODES USING INTERNET
Today, Meliconi gives customers who don’t have internet the chance to receive the codes for programming their remote
control directly on their cell phone.
Simply send an SMS to this number 0039 345 7518893 as follows: 8A, Type, Brand, Model
- Type = indicate the device to be controlled using one of the following abbreviations: TV - SAT - DVD - VCR - TER
(Digital Terrestrial decoder) - AUX (other audio video device).
- Brand, Model = to indicate the brand and the model of the device to be controlled.
Example: 8A, TV, PHILIPS, 32PFL3614 (if you don’t know the model, don’t write anything after the brand).
Once you have received the SMS with the list of codes, set the fi rst code in the remote control as described in the
ENTERING THE CODE DIRECTLY section.
Stand in front of the device with the MELICONI remote control. Turn the device on and then press the OFF button on the
remote (or the PLAY button if the device is a VCR/DVD).
If the device does NOT switch off (or if the VCR/DVD does not start playing), try setting the consecutive code in the SMS
list in the remote control.
When the device reacts check whether the other buttons are operating correctly too.
If they do, the remote control is ready to use.
If they don’t, you are probably using an incorrect code destined for a very similar device; at this point ignore the
SMS list and consult the SETTING CODES USING A MANUAL CODE section to fi nd a more suitable code.
SETTING CODES USING A CELL PHONE
NOTE: If you don’t receive an SMS on your cell phone or if the message says ERROR / NO CODE, it means the
system has not been able to process the data you have sent; Do not try sending another SMS use the MANUAL
SEARCH instead.

MELICONI Fully 8 RC Specifications

General

Type	Universal Remote Control
Brand	MELICONI
Model	Fully 8 RC
Number of Devices Controlled	8
Pre-programmed	Yes
Power Source	Battery
Operating Range	Up to 10 meters
Compatible Devices	TV, DVD, VCR
Batteries Required	2 x AAA