ConnectX-2 Ethernet Card User Manual Rev 1.6
Mellanox Technologies
33
Care should be taken not to impede the air exhaust flow through the ventilation holes. Cable
lengths should be used which allow for routing horizontally around to the side of the chassis before
bending upward or downward in the rack.
To remove a cable, disengage the locks and slowly pull the connector away from the port recepta-
cle. Both LED indicators will turn off when the cable is unseated.
Always install and remove cables by pushing or pulling the cable and connector in a
straight line with the card.
Cables, especially long copper cables, can weigh a substantial amount. Make sure that
the weight of the cable is supported on its own and is not hanging from the adapter
card.
To Next Page
Loading...
Need help?
General
