EasyManua.ls Logo

Mendota FV44I Gen 3 User Manual

Mendota FV44I Gen 3
98 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
85-03-01060-D FV44i Décor Gen 3
Installation and Operating Instructions
MODEL NO. FV44I Décor Gen 3 FULLVIEW DIRECT VENT GAS FIREPLACE INSERT HEATER
WARNING: If the information in these instructions
is not followed exactly, a fire or explosion may
result causing property damage, personal injury or
loss of life.
AVERTISSEMENT. Assurez-vous de bien suivre les
instructions données dans cette notice pour réduire au
minimum le risque d'incendie ou d'explosion ou pour
éviter tout dommage matériel, toute blessure ou la mort.
- Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
appliance.
- WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
If you cannot reach your gas supplier, call
the fire department.
- Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
Ne pas entreposer ni utiliser d'essence ni d'autres vapeurs
ou liquids inflammables dans le voisinage de cet appareil
ou de tout autre appareil.
- QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur. Ne pas vous servir des
téléphones se trouvant dans le bâtiment où vous trouvez.
• Appelez immédiatement votre fournisseur de gaz depuis
un voisin. Suivez les instructions du fournisseur.
• Si vous ne pouvez rejoindre le fournisseur de gaz,
appelez le service des incendies.
- L'installation et l'entretien doivent être assurés par un
installateur ou un service d'entretien qualifié ou par le
fournisseur de gaz.
This appliance may be installed in an aftermarket,
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by local
codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is not
convertible for use with other gasses, unless a
certified kit is used.
Cet appareil peut être installé dans une maison
préfabriquée (É.-U. seulement) ou mobile déjà installée à
demeure si les règlements locaux le permettent.
Cet appareil doit être utilisé uniquement avec les types de
gaz indiqués sur la plaque signalétique. Une trousse de
conversion est fournie avec cet appareil.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this appliance
and must be installed.
Une barrière conçue pour réduire le risque de brûlures
du verre chaud est fournie avec cet appareil et doit être
installée.
Question and Answer IconNeed help?

Do you have a question about the Mendota FV44I Gen 3 and is the answer not in the manual?

Mendota FV44I Gen 3 Specifications

General IconGeneral
BrandMendota
ModelFV44I Gen 3
CategoryIndoor Fireplace
LanguageEnglish

Summary

1 READ ME FIRST

1.1 Initial Firing and Curing Procedure

Describes the initial heat curing cycle for the fireplace, including expected smoke and odor.

1.2 Hot Surfaces Are Normal

Explains that high surface temperatures are normal and outlines safety precautions.

2 GENERAL INFORMATION

2.1 Safety and Warning Information

Covers essential safety requirements, building permits, and general cautions.

3 TECHNICAL REFERENCES

3.1 General Technical References

Provides general technical notes and specific curing instructions for the fireplace insert.

3.2 Mechanical Technical References

Details mechanical aspects including installation, clearances, and specifications.

3.2.2 Clearances to Combustibles Materials Inspection Requirement

Specifies essential clearance requirements to combustible materials for safe installation.

3.2.6 Normal Surface Temperatures

Discusses expected surface temperatures during operation and related safety.

3.2.20 Venting

Provides detailed instructions and requirements for venting the fireplace insert.

3.3 Electrical Technical References

Covers electrical requirements, power connections, and system diagrams.

3.3.1 AC Power Requirements

Details the necessary AC power supply and connection procedures.

3.4 Plumbing Technical References

Outlines requirements for gas supply lines, pressure, and connections.

3.4.1 Gas Supply Requirements

Specifies requirements for the gas supply line, including pressure and sizing.

4 INSTALLATION INSTRUCTIONS

4.1 Installation Checklist

A step-by-step checklist to ensure all installation tasks are completed.

4.10 Natural Gas to LPG Conversion

Provides instructions for converting the fireplace from natural gas to LPG.

4.14 Insert Body Installation

Details the steps for correctly installing the main insert body into the fireplace.

4.17 Air Shutter Control and Flame Appearance

Guides on adjusting air shutters for optimal flame appearance.

5 HOMEOWNER INFORMATION

5.3 Important Information for Homeowner

Highlights crucial information for owners before operating the fireplace.

5.4 Operating Information

Provides guidance on the general operation of the fireplace unit.

5.4.1 Using Your Remote Control

Instructions on how to use and operate the fireplace via the remote control.

5.8 First Time Lighting Instructions

Step-by-step guide for the initial lighting of the fireplace.

5.11 Frequently Asked Questions

Addresses common questions and provides troubleshooting tips.

5.11.1 What to do if I smell gas?

Critical safety instructions for what to do if a gas odor is detected.

6 MAINTENANCE INFORMATION

6.1 Required Periodic Inspections

Details essential periodic inspections for maintaining performance and safety.

6.3 Required Annual Maintenance

Outlines the necessary annual maintenance procedures for the unit.

6.7 Replacement Parts Information

Information regarding available replacement parts for the fireplace.

7 WARRANTY QUALIFICATION AND SERVICE

7.1 Installer Verification Checklist

A checklist for installers to verify proper installation for warranty.

7.2 Warranty Policy Statement

Details the terms, conditions, and coverage of the product warranty.

7.2.4 How to Obtain Warranty Service

Provides instructions on how to contact Mendota for warranty service.

Related product manuals