Mendota FV44i-0616 User Manual

MODEL NO. FV44i - 0616
FullView Direct Vent Gas Fireplace Insert Heater
Installation & Operating Instructions
– Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of
this or any other appliance.
– WH
AT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not
use any phone in your building.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier, call
the fire department.
– Installation and service must be performed by
a qualified installer, service agency or the gas
supplier.
WARNING: If the information in these
instructions are not followed exactly, a fire
or explosion may result causing property
damage, personal injury or loss of life.
This appliance may be installed in an aftermarket
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by
local codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is
not convertible for use with other gassed, unless
a certified kit is used.
A barrier designed to reduce the risk of burns
from the hot viewing glass is provided with this
appliance and shall be installed.

Mendota FV44i-0616 Specifications

General

Model	FV44i-0616
Type	Indoor Fireplace
Fuel Type	Natural Gas or Propane
Vent Type	Direct Vent
Ignition Type	Electronic Ignition
BTU/hr Input	31, 000 BTU/hr
Finish	Black

Summary

Safety and Warning Information

Building Permit and Installation Inspection Approval Requirements

Requirements for permits, inspections, and warranty validation.

Safety Warnings

General safety precautions and warnings for product use and installation.

General Information

Safety and Structural Concerns

Electrical Requirements

Details on power supply, grounding, and electrical connections.

Specifications

General Specifications

Required Clearances

Essential clearance measurements to combustibles for safe installation.

Hearth Protection Pad Requirements

Venting Requirements

General Venting Requirements

Overview of the venting system components and general installation rules.

Venting Installation Instructions

Step-by-step instructions for installing the venting system.

Electrical Requirements

Planning for AC 120 VAC Connection

Gas Supply Requirements

Gas Supply Line Sizing

Gas Pressure Checking

Procedures for checking and setting gas pressures during installation.

Gas Input Rate Verification

Converting Insert for LP Gas

Orifice Size Requirement

Specifies the correct orifice sizes for converting to LP gas.

Procedure to Convert Insert for LP Gas

Step-by-step guide for converting the fireplace from Natural Gas to LP Gas.

LP Pressure Regulator Conversion Instructions

Detailed instructions for replacing the pressure regulator for LP gas.

Checking Burner(s) Ignition Characteristics

Installation Check Off List

Lighting Check Off List

Using the Remote Control

Remote Control Transmitter Functions

Remote Control Transmitter Operating Instructions

Detailed instructions on operating the fireplace using the remote transmitter.

Remote Functions

First Time Lighting Instructions

Safety Information

Essential safety precautions to read before lighting the appliance.

Operating Instructions

Step-by-step guide for the initial lighting sequence of the fireplace.

To Turn Off Gas to Appliance

Trouble-Shooting

Common Trouble-Shooting Information

Trouble-Shooting Mendota Gas Inserts

Specific table detailing symptoms, probable causes, and corrective actions for inserts.

Maintenance

Required Annual Maintenance

Annual maintenance procedures to be performed by a service person.

Periodic Inspections Required

Mendota Warranty & Service Form

Mendota Lifetime Warranty

Extended Lifetime Warranty