Mendota FV33i-PF2-0113 User Manual

INSTALLATION & OPERATING INSTRUCTIONS
FullView Direct Vent Gas Fireplace Insert Heater
With
Premium Texture Fiber Logs Combustion System
In the Commonwealth of Massachusetts:
• Installation must be performed by a licensed plumber or
gas fitter;
• A CO detector shall be installed in the room where the
appliance is installed.
CAUTION
THESE INSTRUCTIONS ARE TO REMAIN WITH THE
HOMEOWNER.
WARNING
If the information in this manual is not followed exactly, a
fire or explosion may result causing property damage,
personal injury or loss of life.
Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
• Open windows.
• Do not touch electrical switches.
• Do not try to light any appliance.
• Extinguish any open flame.
• Do not use the phone in your building.
• Immediately call your gas supplier from a neighbor's
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire
department.
WARNING
Do NOT use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control, which has been under water.
MODEL NO. FV33i-PF2-0113
WARNING: Improper installation, adjustment, altera-
tion, service or maintenance can cause injury or prop-
erty damage. Refer to this manual. For assistance or
additional information consult a qualified installer, ser-
vice agency or the gas supplier.
FOR YOUR SAFETY
A qualified installer, service agency, or the gas suppli-
er must perform installation and service.
Do not store or use gasoline or other flammable va-
pors and liquids in the vicinity of this or any other ap-
pliance.
WARNING
Do not operate this appliance with the glass removed,
cracked or broken. A licensed or qualified person
should do replacement of glass.
WARNING
Mendota gas fireplaces are heat producing appliances.
Do not burn wood, paper or other materials in this fire-
place. This fireplace is designed as a supplement
heat source. It is advisable to have an alternative pri-
mary heat supply.
The installation must conform with local codes or, in
the absence of local codes, with the current National
Fuel Gas Code, ANSI Z223.1, or the current Natural
Gas and Propane Installation Code, CSA B149.1
This appliance may be installed in an aftermarket per-
manently located, manufactured (mobile) home, where
not prohibited by local codes.
This appliance is only for use with the type(s) of gas
indicated on the rating plate. This appliance is not
convertible for use with other
gases, unless a certified
kit is used.

Mendota FV33i-PF2-0113 Specifications

General

Brand	Mendota
Model	FV33i-PF2-0113
Category	Indoor Fireplace
Language	English

Summary

FV33i Features - Quick Reference Information

General Specifications and Clearances

Detailed product specs, clearances, and requirements for the FV33i fireplace.

Initial Startup, Safety, and Installation

Safety and Warning Information

Essential safety guidelines for operating and maintaining the gas fireplace insert.

Installation Approval and High Altitude Guidelines

Permit requirements and guidance for high-altitude installations.

Core Installation Instructions

Step-by-step procedures for installing the fireplace insert and venting system.

Gas and Electrical Supply Requirements

Guidelines for gas supply lines, pressure checks, and electrical hookups.

Pre-Operation Checklists

Checklists for installation verification and initial lighting procedures.

Operation, Maintenance, and Troubleshooting

Door and Log Set Installation

Procedures for removing/installing the door and placing the log set.

FV33i Log Set Installation Guide

Detailed instructions for correctly placing log set pieces for optimal appearance.

Remote Control Operation

Using the remote transmitter to control flame, fan, and other functions.

Pilot Lighting and System Initialization

Procedures for first-time pilot lighting and synchronizing the remote control system.

Maintenance and Burner Flame Adjustment

Annual maintenance tasks and procedures for adjusting burner flames via air dampers.

Troubleshooting Common Issues

Guidance on identifying and resolving common problems like sooting and flame behavior.

Conversions, Parts, and Warranty

Gas Conversion Instructions

Instructions for converting the fireplace from Natural Gas to LP Gas.

LP Pressure Regulator Conversion

Detailed steps for converting the pressure regulator from Natural Gas to LP Gas.

Replacement and Service Parts

List of common replacement parts and ordering information from the dealer.

Warranty Qualification and Service Reference

Process for qualifying for warranty and referencing service information.