40
Motorized
LP Pressure
Regulator
[10.0-5.5"WC]
# 907.012
Burner Orifice
#65-14-00364[3/64"DRILL]
364
364
NATURAL TO LP GAS CONVERSION INSTRUCTIONS
Kit # HA-82-00411 Mendota Model FV33i
This conversion kit shall be installed by a qualified service agency in
accordance with the manufacturer’s instructions and all applicable
codes and requirements of the authority having jurisdiction. If the in-
formation in these instructions is not followed exactly, a fire, explosion
or production of carbon monoxide may result causing property dam-
age, personal injury or loss of life. The qualified service agency is re-
sponsible for the proper installation of this kit. The installation is not
proper and complete until the operation of the converted appliance is
checked as specified in the owner instructions supplied with the kit.
Caution: The electrical supply to the fireplace must be turned off prior
to performing the conversion. The gas supply must be shut off prior to
disconnecting the electrical power.
ORIFICE SIZES REQUIREMENT
:
A Natural Gas to LPG conversion kit #HA-82-00411 is included with
this fireplace insert.
LP Conversion Kit # HA-82-00411 contains the following parts: One Motorized LP Pressure Regulator #907.012,
and two Cap Orifices #65-14-00364(drill #3/64”) and an L-shaped Torx wrench.
Recommended Procedure to Convert This Fireplace To Burn LPG
This Fireplace Insert arrives from the factory ready to burn Natural Gas. If you intend to burn LPG, it is highly recommended
that you convert this fireplace and its Pressure Regulator, Pilot NG/LP clip position and Burner Orifices prior to placing this
fireplace in its fireplace cavity.
See diagrams, on this page, and follow these instructions to prepare this fireplace for conversion to LPG.
1. Using a ¼” Hex Driver, remove 2 screws that secure the Rear and Front burners to the Burner Airbox.
2. Lift Up and remove Front Burner.
3. Loosen Front Burner Air Shutter Screw and rotate air shutter open ¼” minimum. Set burner aside.
4. Slide Rear Burner to the right about 2” and lift up and remove from Firebox.
BURNERS MOUNTING
SCREWS
FRONT BURNER
REAR BURNER
To Next Page