2
INITIAL STARTUP ADVICE
PAINT CURING CYCLE RECOMMENDATION: It is recommended that you run this Insert on maximum flame
height, with the blowers turned OFF, for 3 cycles of 2 hours ON and 2 hours OFF initially to cure the paint.
BLOWER BREAK-IN PERIOD: The integrated blowers in this Insert may exhibit some bearing noise and electri-
cal static noise during the first few hours of operation. This is normal during the break-in period. It is recommend-
ed that following the Paint Curing Cycle, the blowers be run at their maximum speed for two 3-hour periods. The
burner flames may be on or off during these cycles. The blowers in a few inserts may take longer to break-in and
may require additional operation time before all extraneous noise is eliminated. Please allow adequate operation-
al time for the blowers to break-in before you contact your dealer for service.
To Next Page
Loading...
